News

Eccentric Reducer Installation Method

Publish Time: Author: Site Editor Visit: 77

The installation method of Stainless Steel Concentric & Eccentric Reducer mainly includes the following steps:

‌Inspection before installation‌:

Confirm whether the motor and reducer are intact, and check whether the dimensions of the parts connected to the motor and reducer match, especially the dimensions and matching tolerances of the positioning boss of the motor, the input shaft and the groove of the reducer.

‌Adjust the clamping ring‌:

Unscrew the screws on the dustproof hole on the outer side of the reducer flange, adjust the clamping ring so that the side hole is aligned with the dustproof hole, and then insert the hexagon socket and tighten it to ensure the stability and sealing of the installation.

‌Naturally connect the motor and reducer‌:

Naturally connect the motor and reducer to ensure that the output shaft of the reducer is consistent with the input shaft of the motor, and the outer flanges of the two are parallel. If the concentricity is inconsistent, it may cause the motor shaft to break or the reducer gear to wear.

‌Fix the reducer‌:

Fix the reducer to the foundation with anchor bolts to ensure its firmness and stability. During installation, a level should be used to adjust the level of the reducer to ensure that its errors in the horizontal and vertical directions are within the allowable range.

‌Lubrication system installation‌:

Install lubrication components such as oil pipes, oil pumps, and oil tanks according to the design of the lubrication system to ensure that the lubrication system is installed correctly and without leakage.

‌Electrical connection‌:

Connect the power line and control line according to the electrical wiring diagram to ensure that all electrical connections are correct, firm, and well insulated.

‌Trial run‌:

After ensuring that all installation work is completed, perform a no-load trial run to check whether the reducer is operating normally; then perform a load trial run to further confirm whether the reducer's operating status meets the design and use requirements.

‌Precautions‌: During the entire installation process, the operating procedures and safety specifications should be strictly followed to ensure installation quality and personal safety.

Eccentric Reducer Installation Method

This site uses cookies

We use cookies to collect information about how you use this site. We use this information to make the website work as well as possible and improve our services.